Skuttle Indoor Air Quality Products SK0-0055-001 Bedienungsanleitung PDF herunterladen

Page 1

INSTALLATION INSTRUCTIONS

SK0-0055-001 HUMIDISTAT

The humidistat is designed for

either return air duct or wall

mounting

. Packaged in a duct mount configuration,

(For this type

mounting begin installation at the section labeled return air duct

installation on page 2.)

for conversion to a wall mount configuration

simply pull off the knob and remove the mounting screws and rotate the

control 180° and reattach the mounting base, (For this type mounting

begin installation at the section labeled wall mount installation on

page 3.)

DANGER

∗

Do not cut or drill any air-conditioning or electrical

accessories during installation.

∗

Fatal electrocution is possible if you contact a live wire.

∗

Electrical power can cause electrical shock

∗

Disconnect all electrical power supplied to the equipment

before beginning installation.

∗

Blindness can occur if freon contacts your eyes.

CAUTION

∗

Do not install on any electrical system over 30 VAC

CAUTION

∗

All electrical wiring should comply with codes and

ordinances.

At Outside Temperatures Recommended Setting

-20°F -30°C 15%

-10°F -25°C 20%

0°F -20°C 25%

+10°F -10°C 30%

+20°F -5°C 35%

Over 20°F Over 0°C 40%

Recommended Settings

Warning:

Adjusting the

humidity control

higher than the rec-

ommended setting

may cause conden-

sation resulting in

possible damage to

the

home.

1 2 3 4

Inhaltsverzeichnis

Seite 1 - INSTALLATION INSTRUCTIONS

Page 1 INSTALLATION INSTRUCTIONS SK0-0055-001 HUMIDISTAT The humidistat is designed for either return air duct or wall mounting. Packaged in a duct mo

Seite 2 - RETURN AIR DUCT INSTALLATION

Page 2 RETURN AIR DUCT INSTALLATION 1 Locate the humidistat in the return air duct at least 12 in. up stream prior to the humidifier or the humidifier

Seite 3 - WALL MOUNT INSTALLATION

Page 3 WALL MOUNT INSTALLATION 1 Locate the humidistat about 5 ft. above the floor, on an inside wall, away from discharge registers. Also, avoid are

Seite 4 - WIRING INSTRUCTIONS

Page 4 WIRING INSTRUCTIONS CAUTION: ∗ Use the wiring diagram shown for single speed blower operation only. ∗When wiring multispeed blower systems u

Kommentare zu diesen Handbüchern

Keine Kommentare

Skuttle Indoor Air Quality Products SK0-0055-001 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Luftentfeuchter Skuttle Indoor Air Quality Products SK0-0055-001 herunter. Skuttle Indoor Air Quality Products SK0-0055-001 User's Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern